===========================================================================================
=		Fonts on Memstick							=
=		By: TeamOverload, Freeplay, and Skylark					=
===========================================================================================

Intro: So you want to take the first step and load fonts on your memory stick?  Read on to find out how.

Materials:
1. Playstation Portable(Firmware 1, 1.5, 2.0, 2.01, 2.5, or 2.60)
2. At least 4MB free for the fonts
3. FileAssistant 0.4
4. On firmwares 2.0+ eLoader is required, as well as GTA for 2.01+
5. Hex editor

Instructions:
1. Boot up FileAssistant 0.4
2. Go to disk, and change one side over to PSP Bios 1.  Press O on registry to get to the registry.
3. Select Copy, and copy both the system.dreg, and system.ireg files.  
4. Change to The PSP Bios 0.  Select copy, and copy the whole font folder.
5. Exit FIleAssistant, and go into USB mode.
6. Open up the system.dreg file in a hex editor.  Change flash0:/font to ms0:/fontmod. 
7. Save the file.
8. Copy BOTH the system.dreg and system.ireg into the location where you have the parser, such as C:\Documents and Settings\YourName\Parse for easy access.
9. Boot up command prompt, and type cd parse to go to the directory.  After that type fixupdreg2 and it should repair your reg file.
10. Copy the system.dreg and system.ireg back to your PSP.
11. Boot up FileAssistant again.  
12. On one side go to PSP Bios 1 and then go to Registry.
13. FInd where you put your system.dreg and system.ireg and copy them both over to the registry.
14. Exit FileAssistant and enjoy!